Electronics Archives - Page 3 of 32 - CS Electrical & Electronics

All Questions › Category: Electronics

Filter:All Open Resolved Closed Unanswered
What is Cascaded multilevel inverter?
AnsweredAnonymous asked 3 years ago • Power Electronics
452 views1 answers0 votes
What is voltage Levels in CAN Protocol?
AnsweredAnonymous asked 3 years ago • Networks
895 views1 answers0 votes
Why CAN Bus uses differential Cable?
AnsweredAnonymous asked 3 years ago • Networks
804 views1 answers0 votes
In I2C every device should have a unique ID
Answeredvaishnavi.talawar asked 4 years ago • Embedded System
457 views1 answers0 votes
I am trying to compile the code for the ARM Cortex M4 based microcontroller, is the below command sufficient? arm-none-eabi-gcc -c main.c
Answeredvaishnavi.talawar asked 4 years ago • Embedded System
643 views1 answers0 votes
in embedded target development, a locator is used to link all the files
Answeredvaishnavi.talawar asked 4 years ago • Embedded System
937 views1 answers0 votes
How much memory is allocated for PI in C? #define PI 3.141
Answeredvaishnavi.talawar asked 4 years ago • Embedded System
1337 views1 answers0 votes
Which is wrong in the below command (Assume CFLAGS are set) arm_none_eabi_gcc $(CFLAGS )-T*c -o out. elf
Answeredvaishnavi.talawar asked 4 years ago • Embedded System
611 views1 answers0 votes
What is Bit Stuffing?
AnsweredAnonymous asked 3 years ago • Networks
444 views1 answers0 votes
For synchronization of CAN. Prop_Seg >= ……………………………………….?
AnsweredAnonymous asked 3 years ago • Networks
467 views1 answers0 votes
Why CAN-BUS uses NRZ encoding instead of RZ?
AnsweredAnonymous asked 3 years ago • Networks
1104 views1 answers1 votes
How to recover from CAN- Busoff?
AnsweredAnonymous asked 3 years ago • Networks
729 views1 answers0 votes
What Is The Use Of Bit Stuffing?
AnsweredAnonymous asked 3 years ago • Networks
512 views1 answers0 votes
What is Cyclic Redundancy Check?
AnsweredAnonymous asked 3 years ago • Networks
464 views1 answers0 votes
Types of error detected in CAN?
AnsweredAnonymous asked 3 years ago • Networks
496 views1 answers0 votes
What is Featured of CAN Protocol?
AnsweredAnonymous asked 3 years ago • Networks
467 views1 answers0 votes
What is the length of the CRC and CRC delimiter?
AnsweredAnonymous asked 3 years ago • Networks
543 views1 answers0 votes
What are the two types of frame format of CAN?
AnsweredAnonymous asked 3 years ago • Networks
496 views1 answers0 votes
What is the Standard CAN Frame Formats?
OpenAnonymous asked 3 years ago • Networks
302 views0 answers0 votes
CAN is synchronous or asynchronous
OpenAnonymous asked 3 years ago • Networks
478 views0 answers0 votes
Difference between Verification and Validation?
OpenAnonymous asked 3 years ago • Automotive Electronics
335 views0 answers0 votes
Why multiple protocols are used in vehicles
OpenAnonymous asked 3 years ago • Automotive Electronics
302 views0 answers0 votes
Difference between MCU and ECU in Autootive Electronics?
OpenAnonymous asked 3 years ago • Automotive Electronics
2278 views0 answers0 votes
Identify the SOC behind BeagleBoneBlack?
OpenAnonymous asked 3 years ago • Embedded System
500 views0 answers0 votes
In the Linux file system dynamic modules are stored in ____ location?
OpenAnonymous asked 3 years ago • Embedded System
620 views0 answers0 votes
Is the below command OK?
OpenAnonymous asked 3 years ago • Embedded System
451 views0 answers-2 votes
Assume that we have the following configuration -2 partitions on the SD card. What is wrong with the following bootargs
OpenAnonymous asked 3 years ago • Embedded System
373 views0 answers0 votes
How to use CAN step by step procedure?
OpenAnonymous asked 3 years ago • Networks
349 views0 answers0 votes
Half duplex system for communication ha
AnsweredJayesh Bornare asked 3 years ago • Embedded System
371 views1 answers0 votes
paging-systems-could-be-used-to
AnsweredJayesh Bornare asked 3 years ago • Embedded System
448 views2 answers0 votes
Paging systems were based on
OpenJayesh Bornare asked 3 years ago • Embedded System
506 views0 answers0 votes
DECT stands for
AnsweredJayesh Bornare asked 3 years ago • Embedded System
392 views1 answers0 votes
The early FM push-to-talk telephone systems were used in
AnsweredJayesh Bornare asked 3 years ago • Embedded System
370 views1 answers0 votes
———– introduced Frequency Modulation for mobile communication systems in 1935
AnsweredJayesh Bornare asked 3 years ago • Embedded System
369 views1 answers0 votes
The modulation technique used for mobile communication systems during world war II was
AnsweredJayesh Bornare asked 3 years ago • Embedded System
486 views1 answers0 votes
A antenna which attempts to direct all its energy in a particular direction is called as a ………….
AnsweredJayesh Bornare asked 3 years ago • Embedded System
378 views1 answers0 votes
………………… are typically characterized by very small cells, especially in densely populated areas.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
376 views1 answers0 votes
The basic GSM is based on ____________________ traffic channels.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
1800 views1 answers-1 votes
In ………….. Frequency Spectrum is divided into smaller spectra and is allocated to each user.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
381 views1 answers0 votes
fading-of-the-received-radio-signals-in-a-mobile-communication-environment-occurs-because-of
AnsweredJayesh Bornare asked 3 years ago • Embedded System
406 views1 answers0 votes
Which of the following is/are the main part(s) of the basic cellular system
AnsweredJayesh Bornare asked 3 years ago • Embedded System
380 views1 answers0 votes
Which of the following is/are the examples of unguided transmission media? i. Magnetic media ii. Radio Wave iii. Infrared Wave
AnsweredJayesh Bornare asked 3 years ago • Embedded System
311 views1 answers0 votes
Which of the following is/are the examples of guided transmission media? i. Coaxial cable ii. Fiber optic iii. Microwave
AnsweredJayesh Bornare asked 3 years ago • Embedded System
464 views1 answers0 votes
Which of the following is/are the examples of guided transmission media? i. Coaxial cable ii. Fiber optic iii. Microwave
AnsweredJayesh Bornare asked 3 years ago • Embedded System
385 views1 answers0 votes
Data rate depends upon which of the following factors? i. Available bandwidth ii. Digital signal levels iii. Level of noise
AnsweredJayesh Bornare asked 3 years ago • Embedded System
360 views1 answers0 votes
State whether the following statements about analog and digital data are True or False. i. Analog data are collected by sensors. ii. Text and integers are examples of digital data
AnsweredJayesh Bornare asked 3 years ago • Embedded System
345 views1 answers0 votes
… is the communication of data by the propagation and processing of signals.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
380 views1 answers0 votes
… is a measurement of the relative position in time within a single period of the signal.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
623 views1 answers0 votes
A … is an electrical or electromagnetic current that is used for carrying data from one device or network to another.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
417 views1 answers-1 votes
The term RADAR stands fo
AnsweredJayesh Bornare asked 3 years ago • Networks
306 views1 answers0 votes
The gain of a radar transmitting antenna is
AnsweredJayesh Bornare asked 3 years ago • Networks
1133 views1 answers0 votes
In case the antenna diameter in a radar system is increased to four times, the maximum range will be increased by
AnsweredJayesh Bornare asked 3 years ago • Networks
384 views1 answers0 votes
The resolution of pulsed radars can be improved by
AnsweredJayesh Bornare asked 3 years ago • Networks
568 views1 answers0 votes
A RADAR that is used for measuring the height of an aircraft is known as
AnsweredJayesh Bornare asked 3 years ago • Networks
565 views1 answers0 votes
Second-time-around echoes are caused by
OpenJayesh Bornare asked 3 years ago • Networks
753 views0 answers0 votes
A high noise figure in a receiver means
AnsweredJayesh Bornare asked 3 years ago • Networks
1955 views1 answers-1 votes
The sensitivity of a radar receiver is ultimately set by
AnsweredJayesh Bornare asked 3 years ago • Networks
1153 views1 answers0 votes
Increasing the pulse width in a pulse radar
AnsweredJayesh Bornare asked 3 years ago • Networks
438 views1 answers0 votes
compared-with-other-types-of-radar-phased-array-radar-has-the-following-advantages-indicate-the-false-statement
AnsweredJayesh Bornare asked 3 years ago • Networks
488 views1 answers0 votes
ndicate which one of the following applications or advantages of radar beacons is false:
AnsweredJayesh Bornare asked 3 years ago • Networks
391 views1 answers0 votes
« Previous 1 234 5…32 Next »

Share Now