Embedded System Archives - Page 6 of 9 - CS Electrical & Electronics

All Questions › Category: Embedded System

Filter:All Open Resolved Closed Unanswered
LSB bit of a 12C address byte
Openvaishnavi.talawar asked 3 years ago • Embedded System
585 views0 answers0 votes
In order to have communication using 12C, we need
Openvaishnavi.talawar asked 3 years ago • Embedded System
427 views0 answers0 votes
Which file is General would contain a call to the main function?
Openvaishnavi.talawar asked 3 years ago • Embedded System
750 views0 answers-1 votes
In SPI more number slaves with less number of IO lines can be interfaced with
Openvaishnavi.talawar asked 3 years ago • Embedded System
576 views0 answers0 votes
Consider a 32-bit architecture, to the type of instructions set supported by ARM processors are
Openvaishnavi.talawar asked 3 years ago • Embedded System
299 views0 answers0 votes
If we do not specify the executive will filename at the compilation time in GCC, then the compiler creates an executable name as
Openvaishnavi.talawar asked 3 years ago • Embedded System
371 views0 answers-1 votes
While working with Qemu if you want Run you target, you will use the -m option
Openvaishnavi.talawar asked 3 years ago • Embedded System
453 views0 answers0 votes
Choose the correct among the given option below
Openvaishnavi.talawar asked 3 years ago • Embedded System
446 views0 answers0 votes
The memory section organization for a specific target system is described in
Openvaishnavi.talawar asked 3 years ago • Embedded System
987 views0 answers1 votes
To combine a code for the embedded target you would prefer a native compiler
Openvaishnavi.talawar asked 3 years ago • Embedded System
1207 views0 answers-3 votes
Which one of the following allows the programmer to define constants?
Openvaishnavi.talawar asked 3 years ago • Embedded System
376 views0 answers0 votes
ARM Stands for
Openvaishnavi.talawar asked 3 years ago • Embedded System
431 views0 answers0 votes
while working with ARM basic controllers we need to enable interrupts with the help of
Openvaishnavi.talawar asked 3 years ago • Embedded System
391 views0 answers0 votes
in UART it is possible to disable parity if needed
Openvaishnavi.talawar asked 3 years ago • Embedded System
1571 views0 answers-3 votes
Which of the following best states the reason that why the Baud rate is mentioned in serial communication?
Openvaishnavi.talawar asked 3 years ago • Embedded System
339 views0 answers0 votes
How to flip the 8th bit in a given 32 Bit integer? uint32_t val= 0xA1B2C3D4;
Openvaishnavi.talawar asked 3 years ago • Embedded System
816 views0 answers1 votes
identify the best practices wrt exchanging structure
Openvaishnavi.talawar asked 3 years ago • Embedded System
1141 views0 answers0 votes
which of the following produces an assembler file in the compilation process?
Openvaishnavi.talawar asked 3 years ago • Embedded System
487 views0 answers1 votes
strn32f407VG is based on
Openvaishnavi.talawar asked 3 years ago • Embedded System
339 views0 answers0 votes
arm-none-eabi-gcc -c main.c What is the output file name generated by the above command?
Openvaishnavi.talawar asked 3 years ago • Embedded System
364 views0 answers0 votes
which tool takes the object file and searches library files to find the routine calls?
Openvaishnavi.talawar asked 3 years ago • Embedded System
333 views0 answers-1 votes
8) the main importance of ARM microprocessors is providing operation with-
Openvaishnavi.talawar asked 3 years ago • Embedded System
524 views0 answers-3 votes
We can alter the sequence of interrupt priority by assigning the higher priority to any one of the interests by programming the register called –
Openvaishnavi.talawar asked 3 years ago • Embedded System
208 views0 answers1 votes
Identify the correct sequence of the instruction execution cycl
Openvaishnavi.talawar asked 3 years ago • Embedded System
322 views0 answers0 votes
are registers required in 12c?
Openvaishnavi.talawar asked 3 years ago • Embedded System
384 views0 answers-1 votes
Arm_none_eabi_gcc is a
Openvaishnavi.talawar asked 3 years ago • Embedded System
610 views0 answers1 votes
ST32F407VG can work at
Openvaishnavi.talawar asked 3 years ago • Embedded System
687 views0 answers3 votes
WslRegisterDistribution failed with error: 0x8007019e The Windows Subsystem for Linux optional component is not enabled. Please enable it and try again. See https://aka.ms/wslinstall for details.
OpenAnonymous asked 3 years ago • Embedded System
1215 views0 answers0 votes
$ Make arm-none-eabi-gcc -c -mcpu=cortex-m4 -mthumb -o main.o main.c process_begin: CreateProcess(NULL, arm-none-eabi-gcc -c -mcpu=cortex-m4 -mthumb -o main.o main.c, …) failed. make (e=2): The system cannot find the file specified. Make: *** [main.o] Error 2
OpenAnonymous asked 3 years ago • Embedded System
385 views0 answers0 votes
What is Cygwin?
OpenAnonymous asked 3 years ago • Embedded System
359 views1 answers0 votes
How to install STM32CubeIDE step by step?
OpenAnonymous asked 3 years ago • Embedded System
5867 views1 answers0 votes
What is bare metal programming?
OpenAnonymous asked 3 years ago • Embedded System
400 views1 answers0 votes
What is the clocking speed of the processor
OpenChetan Shidling asked 3 years ago • Embedded System
216 views0 answers0 votes
Difference between Reduced Instruction Set Architecture (RISC) & Complex Instruction Set Architecture (CISC)
OpenAnonymous asked 4 years ago • Embedded System
280 views0 answers0 votes
07. We can alter the sequence of interrupt priority by assigning a higher priority to any one of the interrupts by programming a register called _____?
AnsweredAnonymous asked 4 years ago • Embedded System
523 views1 answers0 votes
What is the maximum delay that can be generated with the crystal frequency of 22MHz?
OpenAnonymous asked 4 years ago • Embedded System
991 views1 answers1 votes
What does "p" refer to in ATmega328p?
OpenAnonymous asked 4 years ago • Embedded System
495 views1 answers0 votes
A ______ is a small computer on a single integrated circuit?
OpenAnonymous asked 4 years ago • Embedded System
623 views1 answers0 votes
What is the use of the Prescaler in the operation of the timer?
OpenAnonymous asked 4 years ago • Embedded System
1662 views1 answers0 votes
What is Clock Speed in a microcontroller?
OpenAnonymous asked 4 years ago • Embedded System
789 views1 answers0 votes
Group of 4 bits is called as______?
OpenAnonymous asked 4 years ago • Embedded System
429 views1 answers0 votes
The CISC processors have a larger set of instructions with many addressing nodes. This statement is
OpenAnonymous asked 4 years ago • Embedded System
783 views1 answers-1 votes
What will happen if Data and Code memory is interchanged on a microcontroller with von Neumann architecture?
OpenAnonymous asked 4 years ago • Embedded System
690 views1 answers0 votes
A standard bit in digital electronics, consists of either digit __ or ___
OpenAnonymous asked 4 years ago • Embedded System
480 views1 answers0 votes
Which of the following best states the reason that why the baud rate is mentioned in serial communication?
OpenAnonymous asked 4 years ago • Embedded System
465 views1 answers0 votes
______memory is a type of memory used for temporarily storing "frequently used information" that the system would otherwise have to get from the disk?
OpenAnonymous asked 4 years ago • Embedded System
428 views1 answers0 votes
For high-end applications such as video processing, telecommunications, and image processing, the CISC processor will give better performance compared to the RISC processor?
OpenAnonymous asked 4 years ago • Embedded System
758 views1 answers0 votes
What is the difference between UART and USART communication?
OpenAnonymous asked 4 years ago • Embedded System
475 views1 answers0 votes
Using what the processor wake-up from power-down?
OpenAnonymous asked 4 years ago • Embedded System
487 views1 answers0 votes
If two microcontrollers (one with a 16-bit data bus, one with a 32-bit data bus) are using a crystal with the same frequency, then which of the two will execute the data faster?
OpenAnonymous asked 4 years ago • Embedded System
579 views1 answers0 votes
Which of the following best describes the use of framing in asynchronous means of communication?
OpenAnonymous asked 4 years ago • Embedded System
597 views2 answers0 votes
_____ incorporates the functions of a computer's central processing unit on a single integrated circuit?
OpenAnonymous asked 4 years ago • Embedded System
402 views1 answers0 votes
Which of the following is the logic level understood by the microcontroller/microprocessor?
OpenAnonymous asked 4 years ago • Embedded System
368 views1 answers0 votes
SDA is having a ______ transition when the clock line SCL is high?
OpenAnonymous asked 4 years ago • Embedded System
572 views1 answers0 votes
______ is the time that elapses from when an interrupt is generated to when the source of the interrupt is serviced
OpenAnonymous asked 4 years ago • Embedded System
1142 views1 answers1 votes
When a microprocessor/microcontroller has a 32-bit data bus, how many bytes will it process in a single clock cycle?
OpenAnonymous asked 4 years ago • Embedded System
717 views1 answers0 votes
What is a function of a watchdog timer?
OpenAnonymous asked 4 years ago • Embedded System
467 views1 answers0 votes
The appropriate instruction to be used
OpenAnonymous asked 4 years ago • Embedded System
512 views1 answers0 votes
A RISC processor has no memory unit and uses separate hardware to implement instructions. This statement is:
OpenAnonymous asked 4 years ago • Embedded System
544 views1 answers0 votes
Duplex communication means that both ends of the communication can send and receive signals at the same time. This statement is:
OpenAnonymous asked 4 years ago • Embedded System
528 views1 answers0 votes
« Previous 1…4 567 8 9 Next »

Share Now