All Questions - CS Electrical & Electronics

All Questions › Author "jayeshbornare107"

Filter:Questions Subscribes
Which among the below assertions represent the salient features of PIC in C-18 compi
AnsweredJayesh Bornare asked 3 years ago • Embedded System
304 views1 answers0 votes
Which command-line option of compiler exhibits the banner comprising overall number of errors, messages, warnings and version number after an accomplishment of the compilation process?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
290 views1 answers0 votes
In which aspects do the output functions specified in stdio.h differ from ANSI specified versions?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
460 views1 answers0 votes
What does the 'program idata' section of data memory contain in C-18 Compiler?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
324 views1 answers0 votes
Where is the result stored after an execution of increment and decrement operations over the special – purpose registers in PIC?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
461 views1 answers0 votes
Which instruction is applicable to set any bit while performing bitwise operation settin
OpenJayesh Bornare asked 3 years ago • Embedded System
225 views0 answers0 votes
Which flags of status register are most likely to get affected by the single-cycle increment and decrement instructions?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
242 views1 answers0 votes
Which bit permits to enable (if set) or disable (if cleared) all the interrupts in an INTCON
AnsweredJayesh Bornare asked 3 years ago • Embedded System
335 views1 answers0 votes
The RPO status register bit has the potential to determine the effective address of____
AnsweredJayesh Bornare asked 3 years ago • Embedded System
276 views1 answers-1 votes
Which bit/s should be necessarily cleared in OPTION (SFR) register in order to turn on the weak internal pull-ups of port B?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
469 views1 answers-1 votes
What is the purpose of acquiring two different bits from INTCON register for performing any interrupt operation in PIC 16C61 / 71?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
278 views1 answers0 votes
What is the purpose of a special function register SPBRG in USART?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
310 views2 answers0 votes
Which register acts as an input-output control as well as data direction register for PORTA in bank 2 of RFS?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
243 views1 answers0 votes
Which among the below specified registors are addressable only from bank1 of RFS?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
415 views1 answers0 votes
Grove-GSR Sensor measures the resistance of the people, NOT Conductivity?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
265 views1 answers0 votes
What kind of sensor is the GSR Sensor?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
289 views1 answers0 votes
How many electrodes does the GSR Sensor need?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
328 views1 answers0 votes
Connect Seeeduino-V4.2 to PC by using a ?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
308 views1 answers0 votes
In Hardware, Connect the Grove-GSR to?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
275 views1 answers0 votes
What is Operating voltage?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
301 views1 answers0 votes
The Mega 2560 can be powered via the USB connection?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
286 views1 answers0 votes
GSR stands for?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
281 views1 answers0 votes
The Atmega2560 is an _________ bit chip.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
283 views1 answers0 votes
Does the Atmega2560 have an index corner?
OpenJayesh Bornare asked 3 years ago • Embedded System
240 views0 answers0 votes
Which Arduino Boards use the Atmega2560?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
367 views1 answers0 votes
How much flash memory does the Atmega2560 have?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
326 views1 answers0 votes
What is the Clock Speed AtMega 2560?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
398 views1 answers0 votes
DC Current per I/O Pin is?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
333 views1 answers0 votes
What is the Operating Voltage AtMega 2560?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
354 views1 answers0 votes
It has ____________ digital input/output pins.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
247 views1 answers0 votes
he Mega 2560 is a microcontroller board based on the ?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
260 views1 answers0 votes
The Atmel 8-bit AVR RISC-based microcontroller combines 32 KB ISP flash memory with read-while-write capabilities
AnsweredJayesh Bornare asked 3 years ago • Embedded System
291 views1 answers0 votes
There are __ ADC and __ PWM Pins on the Atmega328.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
263 views1 answers0 votes
How many comparators does the Atmega328 have
AnsweredJayesh Bornare asked 3 years ago • Embedded System
446 views1 answers0 votes
How many timers does the Atmega328 have?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
355 views1 answers0 votes
How much flash memory does the Atmega328 have?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
278 views1 answers0 votes
What is the Pin count for AtMega 328?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
245 views1 answers0 votes
What is the Maximum I/O pins for AtMega 328
AnsweredJayesh Bornare asked 3 years ago • Embedded System
256 views1 answers0 votes
The device achieves throughput approaching?
AnsweredJayesh Bornare asked 3 years ago • Embedded System
246 views1 answers0 votes
It has a modified Harvard architecture ___________ processor core
AnsweredJayesh Bornare asked 3 years ago • Embedded System
267 views1 answers0 votes
The ATmega328 is a _____________ microcontroller
AnsweredJayesh Bornare asked 3 years ago • Embedded System
372 views1 answers0 votes
Weak Robust Equivalence Class Testing is defined as: Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
437 views1 answers0 votes
RADAR system operates in normal temp (28 degC), maximum temp at (70 degC) and minimum temp at (-30 degC) as per the specification. At which temperatures do you test the system for normal boundary value testing? Select one:
OpenJayesh Bornare asked 3 years ago • Embedded System
286 views0 answers0 votes
An input field takes the number from 10 to 50. The boundary values for testing this field are: Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
486 views1 answers0 votes
A black-box test technique is Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
377 views1 answers0 votes
Types of Equivalence Classes are Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
356 views1 answers0 votes
In Equivalent Class Testing, what makes us consider them as equivalent? Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
302 views1 answers0 votes
Equivalence partitioning examples in RL 3 discusses Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
345 views1 answers0 votes
Alpha Testing is: Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
356 views1 answers0 votes
Number of unique test cases generated in Robust Worst-Case Boundary Value Analysis for a function of n variables is Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
914 views1 answers0 votes
A regression test Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
322 views1 answers0 votes
A lock which opens with a sequence of digits is an example for Select one:
OpenJayesh Bornare asked 3 years ago • Embedded System
240 views0 answers0 votes
What are the criteria for good Test Cases? Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
310 views1 answers0 votes
Which of the following is an example of an Error-handlingTesting? Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
350 views1 answers0 votes
What are the two important requirements of class partitioning? Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
316 views1 answers0 votes
The specification: an integer field shall contain values from and including 1 to and including 12 (number of the month) Which equivalence class partitioning is correct? Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
532 views1 answers0 votes
Which of the following types of testing are carried out for an erroneous input by the end user? Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
3881 views1 answers0 votes
Defects are least costly to correct at what stage of the development cycle? Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
630 views1 answers0 votes
A lot consists of 10 good articles, 4 with minor defects and 2 with major defects. Two articles are chosen from the lot at random (without replacement). Find the probability that both are good: Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
2857 views1 answers0 votes
Which one is the valid recommendation for identification of valid equivalence class? Select one:
AnsweredJayesh Bornare asked 3 years ago • Embedded System
332 views1 answers0 votes
« Previous 1 234 5…9 Next »

Share Now