All Questions - CS Electrical & Electronics

All Questions › Author "jayeshbornare107"

Filter:Questions Subscribes
The physical layer is located at the bottom of the OSI model
AnsweredJayesh Bornare asked 3 years ago • Networks
337 views1 answers0 votes
Which problems are about to occur if PCB is not designed properly in a confined manner for digital circuits?
AnsweredJayesh Bornare asked 3 years ago • C#_language
522 views1 answers0 votes
Which among the following assists in obtaining the desired value of wave impedance in reflection phase while designing digital PCBs?
OpenJayesh Bornare asked 3 years ago • C#_language
436 views0 answers-1 votes
Which among the below specified condition is precise in the crosstalk verification mechanism using logic flow in opposite direction with the limit of avoiding dangerous interference in digital PCB designing
AnsweredJayesh Bornare asked 3 years ago • C#_language
1237 views1 answers0 votes
Which among the below mentioned assertions is not a way of cross-talk reduction while designing digital PCBs?
AnsweredJayesh Bornare asked 3 years ago • C#_language
618 views1 answers0 votes
Which among the below stated devices/equipments are preferred for elimination of ground and supply line noise especially in TTL/CMOS / ECL PCB designing?
AnsweredJayesh Bornare asked 3 years ago • C#_language
1037 views1 answers0 votes
Which among the below specified assertions is not a grounding consideration associated with ADC as well as DAC?
AnsweredJayesh Bornare asked 3 years ago • C#_language
721 views1 answers0 votes
Which type of solderability testing is carried out for the generation of solder sample due to immersion of wire or sheet metal specimen in a bath of molten solder?
AnsweredJayesh Bornare asked 3 years ago • C#_language
569 views1 answers0 votes
Which among the below mentioned packages does not belong to the category of 'Small Outline Package'?
AnsweredJayesh Bornare asked 3 years ago • C#_language
680 views1 answers0 votes
Which terminology of PCB represents a thin photo-sensitive polymer by supporting photographic pattern of single traces or IC pads for etching?
AnsweredJayesh Bornare asked 3 years ago • C Language
943 views1 answers-1 votes
Half duplex system for communication ha
AnsweredJayesh Bornare asked 3 years ago • Embedded System
370 views1 answers0 votes
paging-systems-could-be-used-to
AnsweredJayesh Bornare asked 3 years ago • Embedded System
446 views2 answers0 votes
Paging systems were based on
OpenJayesh Bornare asked 3 years ago • Embedded System
505 views0 answers0 votes
DECT stands for
AnsweredJayesh Bornare asked 3 years ago • Embedded System
391 views1 answers0 votes
The early FM push-to-talk telephone systems were used in
AnsweredJayesh Bornare asked 3 years ago • Embedded System
368 views1 answers0 votes
———– introduced Frequency Modulation for mobile communication systems in 1935
AnsweredJayesh Bornare asked 3 years ago • Embedded System
368 views1 answers0 votes
The modulation technique used for mobile communication systems during world war II was
AnsweredJayesh Bornare asked 3 years ago • Embedded System
485 views1 answers0 votes
A antenna which attempts to direct all its energy in a particular direction is called as a ………….
AnsweredJayesh Bornare asked 3 years ago • Embedded System
377 views1 answers0 votes
………………… are typically characterized by very small cells, especially in densely populated areas.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
374 views1 answers0 votes
The basic GSM is based on ____________________ traffic channels.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
1799 views1 answers-1 votes
In ………….. Frequency Spectrum is divided into smaller spectra and is allocated to each user.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
380 views1 answers0 votes
fading-of-the-received-radio-signals-in-a-mobile-communication-environment-occurs-because-of
AnsweredJayesh Bornare asked 3 years ago • Embedded System
405 views1 answers0 votes
Which of the following is/are the main part(s) of the basic cellular system
AnsweredJayesh Bornare asked 3 years ago • Embedded System
378 views1 answers0 votes
Which of the following is/are the examples of unguided transmission media? i. Magnetic media ii. Radio Wave iii. Infrared Wave
AnsweredJayesh Bornare asked 3 years ago • Embedded System
310 views1 answers0 votes
Which of the following is/are the examples of guided transmission media? i. Coaxial cable ii. Fiber optic iii. Microwave
AnsweredJayesh Bornare asked 3 years ago • Embedded System
462 views1 answers0 votes
Which of the following is/are the examples of guided transmission media? i. Coaxial cable ii. Fiber optic iii. Microwave
AnsweredJayesh Bornare asked 3 years ago • Embedded System
385 views1 answers0 votes
Data rate depends upon which of the following factors? i. Available bandwidth ii. Digital signal levels iii. Level of noise
AnsweredJayesh Bornare asked 3 years ago • Embedded System
358 views1 answers0 votes
State whether the following statements about analog and digital data are True or False. i. Analog data are collected by sensors. ii. Text and integers are examples of digital data
AnsweredJayesh Bornare asked 3 years ago • Embedded System
344 views1 answers0 votes
… is the communication of data by the propagation and processing of signals.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
379 views1 answers0 votes
… is a measurement of the relative position in time within a single period of the signal.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
622 views1 answers0 votes
A … is an electrical or electromagnetic current that is used for carrying data from one device or network to another.
AnsweredJayesh Bornare asked 3 years ago • Embedded System
414 views1 answers-1 votes
The term RADAR stands fo
AnsweredJayesh Bornare asked 3 years ago • Networks
305 views1 answers0 votes
The gain of a radar transmitting antenna is
AnsweredJayesh Bornare asked 3 years ago • Networks
1133 views1 answers0 votes
In case the antenna diameter in a radar system is increased to four times, the maximum range will be increased by
AnsweredJayesh Bornare asked 3 years ago • Networks
384 views1 answers0 votes
The resolution of pulsed radars can be improved by
AnsweredJayesh Bornare asked 3 years ago • Networks
568 views1 answers0 votes
A RADAR that is used for measuring the height of an aircraft is known as
AnsweredJayesh Bornare asked 3 years ago • Networks
564 views1 answers0 votes
Second-time-around echoes are caused by
OpenJayesh Bornare asked 3 years ago • Networks
753 views0 answers0 votes
A high noise figure in a receiver means
AnsweredJayesh Bornare asked 3 years ago • Networks
1953 views1 answers-1 votes
The sensitivity of a radar receiver is ultimately set by
AnsweredJayesh Bornare asked 3 years ago • Networks
1152 views1 answers0 votes
Increasing the pulse width in a pulse radar
AnsweredJayesh Bornare asked 3 years ago • Networks
438 views1 answers0 votes
compared-with-other-types-of-radar-phased-array-radar-has-the-following-advantages-indicate-the-false-statement
AnsweredJayesh Bornare asked 3 years ago • Networks
487 views1 answers0 votes
ndicate which one of the following applications or advantages of radar beacons is false:
AnsweredJayesh Bornare asked 3 years ago • Networks
391 views1 answers0 votes
The function of the quartz delay line in an MTI radar is to
AnsweredJayesh Bornare asked 3 years ago • Networks
460 views1 answers0 votes
The function of the quartz delay line in an MTI radar is to
OpenJayesh Bornare asked 3 years ago • Networks
321 views0 answers0 votes
The coho in MTI radar operates at the
AnsweredJayesh Bornare asked 3 years ago • Networks
2386 views1 answers1 votes
The Doppler effect is used in (indicate the false statement)
AnsweredJayesh Bornare asked 3 years ago • Networks
428 views1 answers0 votes
The A scope displays
AnsweredJayesh Bornare asked 3 years ago • Networks
348 views1 answers0 votes
If the target cross section is changing, the best system for accurate tracking is
AnsweredJayesh Bornare asked 3 years ago • Networks
364 views1 answers0 votes
After a target has been acquired, the best scanning system for tracking is
AnsweredJayesh Bornare asked 3 years ago • Networks
652 views1 answers0 votes
. If a return echo arrives after the allocated pulse interval,
AnsweredJayesh Bornare asked 3 years ago • Networks
545 views2 answers0 votes
The IF bandwidth of a radar receiver is inversely proportional to the
AnsweredJayesh Bornare asked 3 years ago • Networks
551 views1 answers0 votes
A high PRF will (indicate the false statement
AnsweredJayesh Bornare asked 3 years ago • Networks
590 views1 answers0 votes
The radar cross section of a target (indicate the false statement)
AnsweredJayesh Bornare asked 3 years ago • Networks
607 views1 answers0 votes
If the ratio of the antenna diameter to the wavelength in a radar system is high this will result in (indicate the false statement)
AnsweredJayesh Bornare asked 3 years ago • Networks
543 views1 answers0 votes
If the antenna diameter in a radar system is increased by a factor of 4, the maximum range will be increased by a factor of
AnsweredJayesh Bornare asked 3 years ago • Networks
666 views1 answers0 votes
If the peak transmitted power in a radar system is increased by a factor of 16, the maximum range will be increased by a factor
AnsweredJayesh Bornare asked 3 years ago • IoT
507 views1 answers0 votes
Weather Maps is an Application of Computer Graphics.
AnsweredJayesh Bornare asked 3 years ago • IoT
432 views1 answers0 votes
Graphics can be ?Graphics can be ?
AnsweredJayesh Bornare asked 3 years ago • IoT
411 views1 answers0 votes
The main element of a video monitor is the ?
AnsweredJayesh Bornare asked 3 years ago • IoT
385 views1 answers0 votes
The primary output device in a graphical system is the ______
AnsweredJayesh Bornare asked 3 years ago • IoT
398 views1 answers0 votes
12 3…9 Next »

Share Now