All Questions - CS Electrical & Electronics

All Questions › Author "mrajasri52gmail-com"

Filter:Questions Subscribes
What are the SI units of mass, length and time respectively?
AnsweredRajasri Mundrathi asked 3 years ago • Power System Analysis
256 views1 answers0 votes
What are the three output conditions of 3- state buffer?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
672 views1 answers0 votes
At which frequency the digital data can be applied to a gate?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
435 views1 answers0 votes
What is the main function of the filter in a rectifier circuit?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
2577 views1 answers-2 votes
What is the radix of the octal number system?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
306 views1 answers0 votes
How much input and output needed for demultiplexer?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
628 views1 answers-1 votes
The number of inputs in a half adder is?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
512 views1 answers0 votes
The basic building blocks of the arithmetic logic unit in digital computers are identified as
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
495 views1 answers1 votes
CMOS technology used in?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
368 views1 answers0 votes
Which insulating layer is used in the fabrication of MOSFET?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
351 views1 answers0 votes
When the PIV rating of a diode is exceeded
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
288 views1 answers0 votes
The Ward- Leonard system is used for controlling the speed of
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
340 views1 answers0 votes
Positive integers must be represented by
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
668 views1 answers-2 votes
Which logic unit is the fastest of entirely the logic families?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
267 views1 answers0 votes
The AND operation is equivalent to
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
693 views1 answers-3 votes
Which of the given logic family provide minimum power dissipation?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
694 views1 answers0 votes
Suppose the output of an XNOR gate is 1. Which of the given input combination is correct?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
787 views1 answers2 votes
One nibble is equal to how many bits
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
280 views1 answers0 votes
Which of the given device used in speed control of a DC motor?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
973 views1 answers0 votes
The logical sum of two or more than two logical products is termed as
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
1162 views1 answers0 votes
DeMorgan's Law states that
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
340 views1 answers0 votes
In three-phase half-wave rectifier, each diode conducts for a duration of
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
506 views1 answers-1 votes
The queue is also known as
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
687 views1 answers-2 votes
A digital circuit that can store only 1-bit is a
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
858 views1 answers-3 votes
The inverter can be classified as
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
1617 views1 answers-1 votes
In the toggle mode, a JK flip-flop has
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
834 views1 answers0 votes
Which of these sets of logic gates are known as universal gates?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
805 views1 answers0 votes
Select one Which id not a current triggering device in semiconductor devices
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
358 views1 answers0 votes
A SCR (Silicon Controlled Rectifier) is a
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
368 views1 answers-1 votes
How many bits are needed to store one BCD digit?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
744 views1 answers1 votes
How many entries will be in the truth table of a 4-input NAND gate?
AnsweredRajasri Mundrathi asked 3 years ago • Digital Electronics
603 views1 answers2 votes
Traffic signal light system is the example of_______.
AnsweredRajasri Mundrathi asked 3 years ago • Control System
319 views1 answers0 votes
Which of the following is the correct formula for the transfer function of an electrical RC phase lag compensating network?
AnsweredRajasri Mundrathi asked 3 years ago • Control System
375 views1 answers0 votes
If the bandwidth of the system is very broad, then the response of system is
AnsweredRajasri Mundrathi asked 3 years ago • Control System
430 views1 answers0 votes
A lag compensator
AnsweredRajasri Mundrathi asked 3 years ago • Control System
484 views1 answers0 votes
The magnitude condition for root locus is________.
AnsweredRajasri Mundrathi asked 3 years ago • Control System
381 views1 answers-1 votes
Which of the following controller is also known as anticipatory controller?
AnsweredRajasri Mundrathi asked 3 years ago • Control System
825 views1 answers0 votes
Transient response is improved in case of
AnsweredRajasri Mundrathi asked 3 years ago • Control System
365 views1 answers0 votes
Error constants of a system are a measure of
AnsweredRajasri Mundrathi asked 3 years ago • Control System
402 views1 answers0 votes
The transfer function of the control system depends on
AnsweredRajasri Mundrathi asked 3 years ago • Control System
1053 views1 answers-1 votes
A system of constant voltage and constant frequency is called _______ system
AnsweredRajasri Mundrathi asked 3 years ago • Control System
857 views1 answers1 votes
A function of one or more variables which provides information about the nature of physical event is called
AnsweredRajasri Mundrathi asked 3 years ago • Control System
310 views1 answers0 votes
In a control system, an integrator is represented by
OpenRajasri Mundrathi asked 3 years ago • Control System
312 views0 answers0 votes
A system is stable for (where GM = Gain Margin and PM = Phase Margin)
AnsweredRajasri Mundrathi asked 3 years ago • Control System
416 views1 answers0 votes
Lead network is used to
AnsweredRajasri Mundrathi asked 3 years ago • Control System
499 views1 answers0 votes
Time taken for the response to rise from zero to 100 % for very first time is called
AnsweredRajasri Mundrathi asked 3 years ago • Control System
453 views1 answers0 votes
For type 1 system with parabolic input, the steady state error is
AnsweredRajasri Mundrathi asked 3 years ago • Control System
313 views1 answers0 votes
Find the Laplace transform for sin(ωt)?
AnsweredRajasri Mundrathi asked 3 years ago • Control System
487 views1 answers0 votes
Lead compensator is used to improve
AnsweredRajasri Mundrathi asked 3 years ago • Control System
417 views1 answers0 votes
Differentiation of parabolic response is a ___________response.
AnsweredRajasri Mundrathi asked 3 years ago • Control System
1216 views1 answers1 votes
The steady state error for ramp input for a type two system is equal to
AnsweredRajasri Mundrathi asked 3 years ago • Control System
348 views1 answers0 votes
Transient state analysis deals with_____.
AnsweredRajasri Mundrathi asked 3 years ago • Control System
402 views1 answers0 votes
Which of the following is/are the example of actuator?
AnsweredRajasri Mundrathi asked 3 years ago • Control System
619 views1 answers0 votes
Which of the following is the characteristics of negative feedback control system?
AnsweredRajasri Mundrathi asked 3 years ago • Control System
427 views1 answers0 votes
In signal flow graph input node is node having only________ branches.
AnsweredRajasri Mundrathi asked 3 years ago • Control System
280 views1 answers0 votes
assume two blocks having gains P and Q, and connected in series with each other, what is the resultant gain using block diagram reduction method?
AnsweredRajasri Mundrathi asked 3 years ago • Control System
328 views1 answers0 votes
The input of the system is depending upon the output quantity, then the system is a
AnsweredRajasri Mundrathi asked 3 years ago • Control System
488 views1 answers0 votes
Which is the Electrical analogous quantity for spring element (K) in force-voltage analogy?
AnsweredRajasri Mundrathi asked 3 years ago • Control System
536 views1 answers0 votes
Why signal flow graph is used?
AnsweredRajasri Mundrathi asked 3 years ago • Control System
384 views1 answers0 votes
Advantages of open loop control system is/are
AnsweredRajasri Mundrathi asked 3 years ago • Control System
340 views1 answers0 votes
« Previous 1…6 789 10 11 Next »

Share Now