Electronics Archives - Page 31 of 32 - CS Electrical & Electronics

All Questions › Category: Electronics

Filter:All Open Resolved Closed Unanswered
Write a verilog code for BIN(binary) TO EXCESS3?
AnsweredChetan Shidling asked 5 years ago • Verilog
2124 views1 answers0 votes
Write a verilog code for BCD Upcounter?
AnsweredChetan Shidling asked 5 years ago • Verilog
451 views1 answers0 votes
Write a verilog code for Mealy?
AnsweredChetan Shidling asked 5 years ago • Verilog
492 views1 answers0 votes
What is verilog?
OpenChetan Shidling asked 5 years ago • Verilog
345 views0 answers0 votes
With increasing temperature the channel current of a MOSFET?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
262 views0 answers0 votes
The best device for use as a switch is?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
349 views0 answers0 votes
What effect does increasing VGS have on the depth of inversion layer?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
283 views0 answers0 votes
At onset of Saturation, what is the voltage between gate and drain end of the channel?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
286 views0 answers0 votes
In a n-channel MOSFET device in saturation, the depth of inversion layer is greater at?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
566 views0 answers-1 votes
Which of the following devices has the highest input impedance?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
454 views0 answers0 votes
A MOSFET can be operated with?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
521 views0 answers0 votes
For an n-channel enhancement mode MOSFET, the drain current?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
305 views0 answers0 votes
For a MOSFET, the gate current is?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
334 views0 answers0 votes
How are zener diodes placed between supply rails internally in MOSFET circuits at the I/O pads for protection against electrostatic discharge?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
299 views0 answers0 votes
The input current of JFET and MOSFET are basically the leakage currents of ____ & ____ respectively?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
676 views0 answers1 votes
Which action plays a significant role in enhancing the conductivity of channel by inducing the free electrons especially in enhancement mode of N-channel MOSFET?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
770 views0 answers-2 votes
FETs are widely applicable in oscilloscopes and voltmeters as an input amplifier as compared to bipolar transistor due to ____?
AnsweredChetan Shidling asked 5 years ago • VLSI CMOS
600 views1 answers0 votes
The N channel enhancement type basically termed as normally-OFF MOSFET works with______?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
450 views0 answers1 votes
Which of the following devices supports a drain current with zero gate to source voltage?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
247 views0 answers0 votes
The term "Polygon" in context of VLSI design refers to?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
715 views0 answers-1 votes
_______is the most popular standard logic device family today?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
328 views0 answers0 votes
Which of the following are accurate wrt EDA tool usage?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
510 views0 answers0 votes
RTL contains?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
308 views0 answers0 votes
Which of the following is/are the different domains of modelling Y-diagram?
AnsweredChetan Shidling asked 5 years ago • VLSI CMOS
713 views1 answers0 votes
What is fullform of ASIC is?
AnsweredChetan Shidling asked 5 years ago • VLSI CMOS
736 views1 answers0 votes
Identify the step in a design flow that generates a Gate level net list?
AnsweredChetan Shidling asked 5 years ago • VLSI CMOS
498 views1 answers0 votes
What is RTL in VLSI?
OpenChetan Shidling asked 5 years ago • VLSI CMOS
996 views0 answers1 votes
Suggest a break circuit configuration for controlling over steer and under steer condition
OpenChetan Shidling asked 5 years ago • Automotive Electronics
379 views0 answers0 votes
Describe the working principle of electronic suspension system
OpenChetan Shidling asked 5 years ago • Automotive Electronics
368 views0 answers0 votes
Describe the working principle of electronic suspension system
OpenChetan Shidling asked 5 years ago • Automotive Electronics
382 views0 answers0 votes
Show how small nodes can be kept from overloading with received messages and message prioritization in case of CAN protocol.
OpenChetan Shidling asked 5 years ago • Automotive Electronics
510 views0 answers0 votes
Why do media-oriented devices need netwoeking? Why is CAN not suitable to transport multimedia? Describe frame format for MOST 25.
OpenChetan Shidling asked 5 years ago • Automotive Electronics
374 views0 answers0 votes
Answer the following with respect to CAN communication i) The CAN node receives the message as 1011110, state whether the received information is error free or not. Assume CRC with a generator polynomial as 1011. ii) What is the generator polynomial used in case of CAN communication. iii) How small nodes can be kept from overloading with received messages Message prioritization in case of CAN protocol
OpenChetan Shidling asked 5 years ago • Automotive Electronics
538 views0 answers0 votes
Why traction control is necessary in automobiles? Suggest a electronic solution of Driving Dynamic control system
OpenChetan Shidling asked 5 years ago • Automotive Electronics
340 views0 answers0 votes
Describe, with the aid of a block diagram, the principle and operation of an Adaptive cruise control system.
OpenChetan Shidling asked 5 years ago • Automotive Electronics
482 views0 answers0 votes
What is the coding technique used in Most Physical layer. Determine how the data 10100111001 is transmitted.
OpenChetan Shidling asked 5 years ago • Automotive Electronics
650 views0 answers0 votes
How failure in master cylinder pressure sensor affects the performance of the ABS, ESP and TCS.
OpenChetan Shidling asked 5 years ago • Automotive Electronics
488 views0 answers0 votes
Derive the expression for determining fuel injector pulse duration (base pulse width Tw) for open loop and closed loop modes using speed-density method of computing mass air flow rate.
OpenChetan Shidling asked 5 years ago • Automotive Electronics
615 views0 answers0 votes
Discuss the configuration and significance of closed loop and open loop operation of Electronic fuel control system and also brief on the configuration and operation of Hybrid vehicle
OpenChetan Shidling asked 5 years ago • Automotive Electronics
406 views0 answers0 votes
How performance is enhanced for TCS with an additional sensor I/P along with conventional wheel speed sensor I/P. Justify your answer with the representative block diagram
OpenChetan Shidling asked 5 years ago • Automotive Electronics
381 views0 answers0 votes
How the engine performance can be controlled using ignition timing? Suggest a suitable Instrumentation system with related electronics for closed loop control of ignition timing.
OpenChetan Shidling asked 5 years ago • Automotive Electronics
362 views0 answers0 votes
explain the operation of Automatic Transmission System? How different Gear ratios can be obtained in Automatic Transmission System?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
357 views0 answers0 votes
Determine the fuel injector pulse duration (base pulse width Tw) and fuel the fuel quantity for the four cylinder engine operating in open loop mode with 6000 rpm, having a fuel flow rate of 0.0022Kg/sec and mass ait flow rate of 0.0035Kg/sec
ResolvedChetan Shidling asked 5 years ago • Automotive Electronics
1150 views0 answers1 votes
Describe the performance of an engine with respect to EGR, Air fuel ratio and ignition timing with the necessary plots. What are EURO and Bharat standards?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
415 views0 answers0 votes
Explain diagnostic tools applied to auto motives?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
393 views0 answers0 votes
Discuss different diagnostic protocols in automotive electronics?
OpenChetan Shidling asked 5 years ago • Analog Electronics
302 views0 answers0 votes
Explain fault detection and correction?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
450 views0 answers0 votes
Distinguish between on board and off board diagnostics?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
525 views0 answers0 votes
Differentiate between basic and multiplex wiring system?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
872 views0 answers0 votes
Write a short note on safety process for product life cycle?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
369 views0 answers0 votes
Describe the safety standard ISO 26262?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
445 views0 answers0 votes
Write a short note on autonomous vehicle?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
422 views0 answers0 votes
Differentiate between cruise control and adaptive cruise control?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
385 views0 answers0 votes
Explain the sequence of operation of driver's air bag?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
498 views0 answers0 votes
Explain the functions of different layers of CAN?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
537 views0 answers0 votes
Explain the need for ECU communication in an auto motives?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
454 views0 answers0 votes
With schematic and plot, analyze the engine performance with respect to exhaust gas recirculation?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
364 views0 answers0 votes
With a neat schematic explain the functions of 3-way catalytic converter?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
316 views0 answers0 votes
Determine the fuel injector pulse duration (base pulse width Tw) and fuel quantity for the four cylinder engine operating in open loop mode with 6000rpm, having a fuel flow rate of 0.0022Kg/sec and mass air flow rate of 0.0035Kg/sec.?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
553 views0 answers1 votes
Imagine you are driving at a higher altitude explain how engine control system responds to the change in the engine load increased by the driver demand?
OpenChetan Shidling asked 5 years ago • Automotive Electronics
483 views0 answers0 votes
« Previous 1…29 303132 Next »

Share Now